Garbage Semi Trailer

Garbage Semi Trailer CHASSIS the semi-trailer chassis will be manufactured with welded constructioned with l-profile high-resistant plate steel. the two l-profiles will be attached to each other with welded traverses. on the lower side of the chassis will be axle group of the landing legs and the king-pim group. BODY manufactured at different widths and varities to withstand the loads the crater holds. within trailer side walls st-52 3 mm, floor st-52 6 mm whole trailer will be supported with u-profile frames from outside.on the sides of the body will be at least two waste water tanks with a capacity of 250 lt produced with quality stainless steel. including all hydraulic, engine, oil tank other units, except the rear hopper will have a capacity of 50m3 and the rear hopper will be at least 2,5m3. REAR GATE the rear gate will be connected to the body from back top with slot joints. when the rear gate is closed, will be locked automatically and the lock flanges will be under floor rear traverse, on the rear edge of the body. to guarantee the leaktightness, there will be a removable gasket not affected by the acids between the rear gate and the body. there will be a loading hopper manufactured with resistent material on the sides located in the rear gate with a capacity of 2.5m3. waste loaded here will be taken inside the body with a double effective hydraulic cylinder-driven compression mechanism with a working pressure of 170 bars. the compression mechanism will be consisted of a slide, moving linearly inside the steel sledges and a shovel sweeping the waste in the loading hopper that moves while rotating on this slide. the steel plate of the shovel will be of hardox 400 or similar. sliding shoes will be placed outside the side walls of the rear gate and its contact with